Central Machinery bench drill press Spécifications

ASSEMBLY ANDOPERATING INFORMATION3491 Mission Oaks Blvd., Camarillo, CA 93011Visit our Web site at http://www.harborfreight.comCopyright © 2001 by Har

SKU 44836 PAGE 105. The Drill Press is now set to drill holes to your pre-determined depth, provided thesurfa

SKU 44836 PAGE 115. Set the depth of drill bit travel so that the drill bit cannot come into contact withthe

SKU 44836 PAGE 12FIGURE G

SKU 44836 PAGE 13PLEASE READ THE FOLLOWING CAREFULLYTHE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PAR

DESCRIPTIONHead w/Pointer & TrimMotorHex Nut M8Washer 8Cord - MotorHex Nut M10Lockwasher 10Bracket - MotorHex Head Screw M8 x 1.25-20Support - Mot

SKU 44836 PAGE 15ASSEMBLY DIAGRAM BNOTE:Some parts are listedand shown for illustra-tion purposes only, andar

PARTS LIST/ASSEMBLY DIAGRAM CSKU 44836 PAGE 16NOTE:Some parts are listed and shown for illustrationpurposes

1. KEEP WORK AREA CLEAN AND DRY. Cluttered, damp or wet work areas inviteinjuries.2. KEEP CHILDREN AWAY FROM WORK AREA. Do not allow children to han

SKU 44836 PAGE 35. USE EYE, HEARING, AND BREATHING PROTECTION. Wear ANSI approvedsafety impact eye glass

sure this product is always plugged into a grounded 3-hole electrical receptaclewith an appropriate breaker switch in-line.2. MAKE SURE THE POWER SWIT

SKU 44836 PAGE 510. CAUTION: Some woods contain preservatives such as copper chromium arsenate(CCA) which can be

SKU 44836 PAGE 63.To attach the Head Assembly (part #1B) to the Column (part #1A), loosenthe Hex Screws (par

Bolts of appropriate length, Washers and Locknuts (not provided).To Install/Reposition The Drive Belts:1. The Drill Press features 12 speed selections

SKU 44836 PAGE 8To Obtain The Proper Cutting Speeds:1. Factors which determine the best speed to use in the Dr

To Adjust The Table:1. The Table (part #9A) may be adjusted in 4 directions.2.To raise or lower the Table, release the Table Clamp (part #11A), and tu